| Previous | Contents | Index |
This chapter contains procedures for installing or upgrading to version 6.8 of PMDF, PMDF-MTA, PMDF-MSGSTORE, PMDF-POPSTORE, and PMDF-TLS on an OpenVMS system.1
You will be asked during the installation procedure what optional PDMF add-on layered products should be installed along with PMDF.
The PMDF-MSGSTORE, PMDF-POPSTORE, and PMDF-TLS add-on products cannot be installed separately from the base PMDF kit. Note that PMDF-POPSTORE and PMDF-MSGSTORE are partially installed automatically with the base PMDF kit, although they cannot be used for more than a few sample users unless you have installed a separate license for the respective layered product. |
You will need a Product Authorization Key (PAK) to activate each additional add-on layered product you install. However, you can install a PMDF layered product even if you do not have a PAK for it. In that instance, you will not be able to use that layered product until you have registered and loaded the correct PAK. If you do not install a layered product during the first installation, and later decide to add that particular product, you will have to re-install all the products you use again when you install the particular layered product for the first time.
1 The PMDF product that existed before September, 1994 was subdivided into two products: PMDF-MTA and PMDF-ACCESS. If you have a license PMDF, then you have all three products. PMDF-MTA is considered the base product. The other two products are add-ons. |
| Previous | Next | Contents | Index |